U0003 BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

U0003 Code Symptoms :

If your vehicle failed a U0003 test and the U0003 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U0003 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing U0003

U0003 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix U0003 code ?

• EVAP system hose leaking
• Damaged ECM
• Damaged ECM
• Intake Valve Timing Control Solenoid Valve circuit poor electrical connection

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.